The pictures below show a sample of the different parts that that we've assembled. |
| |
 |
| 3-Layer Flex Assembly |
This flex assembly has SMT connectors and stainless steel stiffeners. Note also the silver epoxy layer covered with non-conductive ink and soldermask. This part is used in the hinge of a cell phone. |
|
|
| |
 |
| 4-Layer PCB Assembly |
This PCB has LED, capacitor, resistor, and IC assembly. It is used to light up the display of a cell phone. |
|
|
| |
 |
| 3-Layer Flex Assembly |
This multi-layer flex has ZIF-type termination as well as an assembled speaker and EMI filter. This part is used in a flip cell phone. |
|
|
| |
 |
| 3-Layer Flex Assembly |
This flex assembly has LED's, resistors, and two dome arrays - one for the side buttons and one for the main keypad. The part is then mounted on a molded plastic speaker box. This is used in a cell phone that Push-To-Talk capabilities. |
|
|
| |
 |
| 6-layer Flex Assembly |
This flex has 6-layers, however, in the dynamic area, the 6-layers are independent of one another - for more flexibility. Two SMT connectors are also assembled. This part goes through the hinge of a flip cell phone. |
|
|
| |
 |
| 3-layer Flex Assembly |
This flex consists of 3-layers and has SMT connector, LED, IC, capacitor, and resistor assembly. Also, assembled is the EL (electro-luminescent) keypad. This part is used in the keypad of the flip cell phone. |
|
|
| |
